Advertisement

Samles position in the tray disappeared from method and run control window on ChemStation (Agilent 6890)

avatar: Alicocca
Alicocca
5 posts
Replied to Alicocca's post on September 14th, 2015

Hi everyone,

I have updated the ChemStation version on a Agilent 6890 GC, couple of months ago, and on the method and run controll window I had many usefull informations, other than the signal, as the instruments actual, and there was a diagram showing wich samples was being analised.

I remember there is a check-list where you could decide wich utiliy to visualize, but I couldn't find again.

Does anyone knows how to do it?

Thank you in advance to anyone who may answer.

Best Regards,

 

Alice Ughi

avatar: Dan Ste.Marie
Dan Ste.Marie
438 posts
Replied to Alicocca's post on September 16th, 2015

Alice,

What version of ChemStation are you using now?

Dan

avatar: Dan Ste.Marie
Dan Ste.Marie
438 posts
Replied to Alicocca's post on September 16th, 2015

Alice,

What version of ChemStation are you now using?

Dan

avatar: Alicocca
Alicocca
5 posts
Replied to Alicocca's post on September 17th, 2015

Hi Dan,

thank you for your reply!

I played a little bit with the software and found the right button.

Have a nice day.

Best wishes

Alice

avatar: imessageonpc
imessageonpc
1 posts
Replied to Alicocca's post on May 3rd, 2019

To utilize ipadian 2 simulators, then it is important for you to tap here and know more about the steps for installing iMessage on PC.