Advertisement
avatar: jbryan
jbryan
1 posts
Replied to jbryan's post on July 12th, 2016

Is there a functioning and/or defunct Polychrome IV out there. In great need of a manual or the RS232 controller program for the TILL polychrome IV. Thank you

avatar: liemnico
liemnico
2 posts
Replied to jbryan's post on July 9th, 2018

Hello Ryan,

this is quite an old thread. But since I have the very same problem with the manufacturer (or its successor ThermoFisher), I would be happy to get in touch with you! I was supplied with three manuals, at least there is some information on the RS-232 included.

avatar: Y Sun
Y Sun
1 posts
Replied to liemnico's post on July 18th, 2018

Hi Liemnico

Our lab also has the Polychrome IV, which has some problem. If possible, could you send me manuals about it ?

 

Thanks!

avatar: AnnaG
AnnaG
4 posts
Replied to Y Sun's post on September 12th, 2018

Hi, Y Sun! Our lab has Polychrome IV too, I have a manual for it, if you still need this, please let me know. I can send it to you. I have a question about calibration polychrome, have you ever did it?  

avatar: liemnico
liemnico
2 posts
Replied to AnnaG's post on September 13th, 2018

Hi AnnaG,

Eventually, we switched to the Polychrome V device. Also, I created a manual on how to calibrate it. Maybe there'd be some helpful advice in there for you as well? We are relying on the same 'calibration photodiode' that one is supposed to use for calibration of the Polychrome IV device. 

Could email it to you, I'll try sending a private message...

avatar: AnnaG
AnnaG
4 posts
Replied to liemnico's post on September 13th, 2018

Hi! Leimnico. Thank you so much if you can share with me information about calibration procedure. I'll send my email by private message. I have another question:''Are you calibrated system only by calibration photodiode or you use 380nm and 505nm filters?'' And it may be you know where I can buy them.