avatar: Guri
53 posts
Replied to Guri's post on December 5th, 2018

I have looked at the various answers over the issue of the centrifuge not turning on after it has been turned off. The 5415R control board is different than the 5415D. I have tried to replace the the 2.2uf capacitor to a 10uf capacitor as explained without any success. Also the four 68K resistors are replaced with 8 ohms and add up to 32 ohms. The same situation happens when the ribbon cable is disconnected while the power is on, it will reset. Does anyone have any ideas!

Thanks for your help



avatar: SaharaSimba
71 posts
Replied to Guri's post on December 8th, 2018
Hi Guri... I can assist with repairs on the board if you send it to me. And will work with you if you are on a tight budget. See my info
avatar: Tech
5 posts
Replied to Guri's post on January 8th, 2019
Did you ever fix your issue? The capacitor needs to be at least 22 uF 35V.