Advertisement
avatar: Jeff N.
Jeff N.
2 posts
Replied to Jeff N.'s post on December 27th, 2018

all 3 conveyor motors will not run. They seem to engage but no movement, and then I get the following fault. "motor protection: motor stop (0) 2001". Any help or expertise would be appreciated. Already swapped out the SXP module and tried a known good motor swap on all 3 conveyors.

avatar: jburkman11
jburkman11
198 posts
Replied to Jeff N.'s post on December 27th, 2018

HiSpeed RS2 is not supported at this forum or address.

Please call 800-836-0836

avatar: Jeff N.
Jeff N.
2 posts
Replied to Jeff N.'s post on December 27th, 2018

ID tag on the equipment shows RX2. Was hoping for some technical help since M.T. is not supporting our older checkweighers anymore. Very hard to find any forums at all that discuss the older in lines. If I were in charge of Purchasing we would get them all replaced, but unfortunately I am just the guy that has to try and keep them running.

avatar: jburkman11
jburkman11
198 posts
Replied to Jeff N.'s post on December 27th, 2018

This forum is for products used in the Laboratory only. Hi-Speed is a different division, at a different location and is a sister Mettler Toledo company