Advertisement
avatar: Hary
Hary
2 posts
Replied to Hary's post on February 22nd, 2019

I am facing 'Error 2' problem in Eppendorf Centrifuge Model 5810R after replacement of cotrol/ converter PCB. Also I have tried to perform imbalance compensation and during this 'Error 36' observed on display. Can anyone help me out to resolve this issue?

avatar: WarwickJon
WarwickJon
73 posts
Replied to Hary's post on March 6th, 2019

Quote Hary

I am facing 'Error 2' problem in Eppendorf Centrifuge Model 5810R after replacement of cotrol/ converter PCB. Also I have tried to perform imbalance compensation and during this 'Error 36' observed on display. Can anyone help me out to resolve this issue?

Hi Hary, 

Error 36 is - EEPROM not yet initialized.  You may need to enter the serial number or machine number of the machine to tell the new PCB exactly which unit it is in.

This is in service function SE5.  Then I'd imagine you'd have to perform the imbalance procedure again.

 

avatar: Hary
Hary
2 posts
Replied to WarwickJon's post on March 7th, 2019

Hi,

Thanks for your reply.

I have gone through service function SE5 but I am unable to write the machine serial no. Kindly send the procedure to entermachine's serial no.  The quipment displays as below;

             INIT 2

  1. Anz./ Tast.
  2. HLZ/BRZ
  3. Unwucht A
  4. Unwucht W
  5. Notentrieg
  6. Initial.
  7. Pr. unvollst