avatar: Hanke
2 posts
Replied to Hanke's post on August 5th, 2019

Error 6 appears upon starting the spin or as soon as it reaches set speed. Also, the speed knob needs to be turned slowly to ensure you reach your desired setting.

avatar: SaharaSimba
81 posts
Replied to Hanke's post on August 13th, 2019
First thing to do is check your brake resistor with a ohm meter . Resistance at the connector on the board should be about a little over or under 100 Ohms. If it reads open check connection or the brake resistor. If the error persists, your Frequency Converter is most likely faulty. Visit Sahara Simba Electronics ... we provide guidance, parts , repair services and sales
avatar: Joshua A. Price
Joshua A. Price
33 posts
Replied to SaharaSimba's post on August 14th, 2019

Pretty good post. I just stumbled upon your site and wanted to say that I have really enjoyed reading your posts. Our Site