Advertisement
avatar: AAKond
AAKond
4 posts
Replied to AAKond's post on March 8th, 2020
The autosampler got stuck while performing a seq run on ABI 3130xl. The machine does not work after this. Any recommendations or trouble shooting?
avatar: aligator
aligator
22 posts
Replied to AAKond's post on March 8th, 2020

Hi,

Normally is a problem in Z way.

You need check the switches and wires.

Sincerely

avatar: aligator
aligator
22 posts
Replied to AAKond's post on March 8th, 2020

Hi,

Normally is a problem in the Z way.

You need check the switches and wires.

Sincerely.

avatar: AAKond
AAKond
4 posts
Replied to aligator's post on March 10th, 2020

Yes, the autosampler moves in the front towards the door, then to left and stops. But does not move upwards and back to the cap position. Which are the wires and switches to be checked? Thank you for your reply.

avatar: AAKond
AAKond
4 posts
Replied to aligator's post on March 10th, 2020

Thank you for your reply. Yes, the autosampler moves to the front towards the door, then left but does not move upwards and back to the capillary position. Which switches and wires need to be checked?

avatar: aligator
aligator
22 posts
Replied to AAKond's post on March 11th, 2020

Plese move this conversation to pvelasco104@gmail.com

avatar: Everhart
Everhart
46 posts
Replied to aligator's post on March 12th, 2020

This is an exaggeration of truth, it is an obvious marketing strategy. click here