Advertisement
avatar: lmb
lmb
1 posts
Replied to lmb's post on April 1st, 2013

We have a Bellco 744-01010 orbital shaker and would like to replace the drive belts using the preventative maintenance kit available from Bellco (part # 9005-01000). Is there a technical manual available with instructions for how to do this?

 

avatar: LG1
LG1
12 posts
Replied to lmb's post on October 31st, 2019

Know this post is old but for anyone else, this is how you access the belts. Lift up the rubber mat on top of the platform and loosen the 4 screws underneath, Remove upper platform then pop off the retaining clips at the top of each of the 4 posts to remove lower platform. Then remove 4 srews on sides of shaker (2 on each side) to remove cover. Inside there are 2 belts. They are both the same, Bellco part number is A500-176 or you can use a #230 o-ring.