Advertisement

Netzsch DMA 242 C

Dynamic mechanical multi-talent for visco-elastic properties

TA Instruments Q800

The Q800 utilizes state-of-the-art, non-contact, linear drive technology to provide precise control of stress, and air bearings for low friction

PerkinElmer DMA 8000

The PerkinElmer DMA 8000 is one of the most flexible, cost effective Dynamic Mechanical Analyzers available today. Its innovative design, high

Triton Technology TTDMA

The TT DMA enables you to study the mechanical properties of your materials under a variety of conditions from -190 °C to 600°C with excellent

TA Instruments RSA-G2

The new RSA-G2 is the most advanced platform for mechanical analysis of solids. The separate motor and transducer technology of the RSA-G2 insures

Netzsch DMA 242 E Artemis

The DMA 242 E Artemis has replaced the DMA 242 C        The new DMA 242 E Artemis combines ease of handling with the user-friendly

EXSTAR DMS7100

Viscoelasticity measurements transforms the samples by bending, tension, shearing etc.

Hitachi Dynamic Mechanical Analyzer DMA7100

With its exceptional overall performance and user-friendly design, the DMA7100 is ideal for uses from routine and high-level research. A navigation

Dynamic Mechanical Analysis Community

Join the Dynamic Mechanical Analysis Community and receive updates on all related articles, forums, and equipment.

Ask a Question

Please enter all fields

Add a Post to Browse Categories Questions and Answers


Advertisement

Advertisement

Questions and Answers

Questions for Dynamic Mechanical Analysis

Compression compliance calibration error

I have recently encountered an error with the code 316 defined with the title "Sample is too weak" during the compliance calibration step...

S. P. Zaoutsos

I apply a test procedure in DMA Q800 and the device starts working for a couple of seconds and after that it returns the message "Slide...

Cannot start a multifrequency run

Recently, I encountered the following problem. I define a procedure for running a multi-frequency method, and click start. The instrument appears to...

Recurrent Air Bearing Issue

Hello - I have a Q800 DMA with a recurrent air bearing Issue.  TA has been here to fix it once but it quickly stopped working again.  I...

Power supply error

Does anyone know how I can fix the following error on our Q800 DMA instrument?  "power supply furnace impredance error(405)"

See all Dynamic Mechanical Analysis Questions and Answers

Advertisement

Advertisement

Advertisement