Setaram Instrumentation - microDSC3 evo

Manufactured by  Setaram Instrumentation
Follow this Equipment

High-sensitivity DSC and isothermal microcalorimetry (-20 to 120°C) with in-situ mixing possibilities

ΜDSC3 evo is the lastest generation of the most popular microcalorimeter of Setaram. Its high sensitivity and versatility makes this instrument a star in many industrial and academic research laboratories all around the world.
Active Questions & AnswersAsk a Question

There are no current Discussions

Need Equipment Support?

Request Support
Features of microDSC3 evo
  • Wide operating temperature range (from -20 °C to 120 °C): Cooling of the calorimeter does not require an external source.    
  • Very low detection limit: The µDSC3 evo detection limit is significantly lower (by a factor of about ten) than that of traditional DSCs. Calorimetric signals of less than one Microwatt can be detected. The very high sensitivity of the µDSC3 evo enables transition studies to be performed on small quantities of products and at very low programming speeds.    
  • Use in isothermal or temperature programming (DSC) mode.    
  • Possibility of studying samples in all forms: liquid, gel, powder, solid.    
  • Large range of experimental cells: including specific cells for studying reactions, providing numerous application possibilities.    
  • Ease of operation: dedicated market leading CALISTO software that is not only intuitive but powerful enough to perform all typical experiments and data treatment.
General Specifications
Cooling Rate0.001 to 1.2 °C/min
Depth 22.8 in
DSC TypeHeat Flux DSC
Height15.7 in
Temperature Range-20 to 120 °C
Width 20.9 in
Heating Rate0.001 to 1.2 °C/min
Power Requirements 230 V - 50/60 Hz
Weight82.5 lbs
Additional Specifications

Temperature range:     
-20 °C to 120 °C (Cooling under 0 °C requires the use of an auxiliary thermostat)    
Programmable temperature scanning rate (heating and cooling):     
0.001 to 1.2 °C.min-1-1    
RMS Noise:     
0.2 µW    
Resolution:     
0.02 µW / 0.002 µW    
Cells ("batch" or circulation):     
1 ml - made of Hastelloy C - Removable    
Pressure (measured & controlled):     
400 bar / 5800 psi, requires the use of High Pressure cells and gas panel

Looking for New or Used Equipment?

Shop on LabX

Shop on Labx.com