Shimadzu - AG-Xplus Series
Manufactured by Shimadzu
No Documents
Short Test Cycle Time:> Selecting a 5 kN max. HS table-top type with a 3300 mm/min return speed and 3000...
Short Test Cycle Time: Selecting a 5 kN max. HS table-top type with a 3300 mm/min return speed and 3000 mm/min crosshead speed reduces the test cycle time for specimens that stretch, such as rubber.
Short-column Type (Model SC) Added: Ideal for the compression testing of small parts, such as electrical and electronic components. It offers a 700 mm testing space, and the 1130 mm test height permits installation in a room with a low ceiling.
Power-saving Standby Mode Reduces Environmental Stress: The AG-Xplus reduces the power consumption in standby mode, cutting CO2 emissions and reducing the environmental stress. Power savings of approximately 10 to 25 % are possible, depending on the frame capacity.
Short-column Type (Model SC) Added: Ideal for the compression testing of small parts, such as electrical and electronic components. It offers a 700 mm testing space, and the 1130 mm test height permits installation in a room with a low ceiling.
Power-saving Standby Mode Reduces Environmental Stress: The AG-Xplus reduces the power consumption in standby mode, cutting CO2 emissions and reducing the environmental stress. Power savings of approximately 10 to 25 % are possible, depending on the frame capacity.
Active Questions & AnswersAsk a Question
There are no current Discussions
Need Equipment Support?
Documents & Manuals
There are no Documents or Manuals available.
Features of AG-Xplus Series
Easy Stress and Strain Control: Features autotuning of the control parameters in real time based on stress and strain data measured during testing as well as reliable comparison of unknown sample data, without pre-testing. In addition, the autotuning function easily provides the strain control required by ISO 6892-2009.
- Steel Industry: The steel industry is receiving more demands from the automobile industry to test under strain control in addition to stress control
- Plastic Industry: In the plastics industry, strain control is essential for calculating the modulus of elasticity according to new JIS, using the leading edge of the stress-strain curve
- Ceramics Industry: In the ceramics industry, accurate control is demanded initially, as the specimen fails after undergoing minute displacements
General Specifications
There are no General Specifications available.