Buck Scientific - PFP-7

Manufactured by  Buck Scientific
Follow this Equipment

PFP-7 Flame Photometer

The Model PFP-7 is a low temperature, single channel flame photometer designed as a low cost approach for the routine determination of sodium and potassium. Additional filters are available for the measurement of lithium, barium, and calcium.
Active Questions & AnswersAsk a Question

There are no current Discussions

Elemental Analyzers Service ProvidersView All (4)

Request Support
Documents & Manuals

There are no Documents or Manuals available.

Features of PFP-7
  • Push button ignition  
  • Switchable decimal point  
  • Electronic flame failure detection  
  • Filter wheel for fast changing of analytical parameters  
  • Fine and coarse sensitivity controls  
  • Operates on propane, butane, natural gas or L.P.G. supplies  
  • Recorder output  
  • Economically priced  
  • Electronic Flame Failure Sensor  
  • Independent Zero and Gain Controls with an Off-Set Capability on the Zero Control  
  • High Resolution to 0.1 PPM  
  • Universal Voltage/Frequency Operation  
  • Built-In Power Sockets for Operating Recorder or Autosampler
General Specifications
Weight8 kg
Additional Specifications

Reproducibility: <1% coefficient of variation for 20 consecutive samples using 10ppm Na set to read 50.0  
Linearity: Better than 2% when concentration of 3ppm Na and K and 5ppm Li are set to read 100  
Specificity: Interference from Na, K, and Li equal in concentration to test element will be less than 0.5%  
Recorder Output: Nominal 1.00V for a reading of 100.0  
Services: Electrical: 90 - 125V or 190 - 250V @ 50 / 60Hz  
Air: Moisture and oil free 6 liter / minute at 1Kg/cm2 (14psi)  
Fuel: Propane, butane, natural, gas, or L.P.G.  
Range: 0 - 199.9  
Size: 420 x 360 x 300mm

Looking for New or Used Equipment?

Shop on LabX

Shop on Labx.com