Phase II - Coating Thickness Gage with Two External Probes
No Documents
The new PHASE II PTG-3525 can perform two different methods of calculating thickness measurement by utilizing the...
The new PHASE II PTG-3525 can perform two different methods of calculating thickness measurement by utilizing the characteristics of both eddy current and magnetic induction. Testing performance is both non-destructive and extremely accurate.
With this state of the art thickness gage, you can easily detect the thickness of non-magnetic coating on a magnetic substrate (ferrous) or an insulating coating on a non-magnetic conductive substrate (non-ferrous) utilizing our version that comes with 2-external probes.
The PHASE II PTG-3525 can be used in many areas of industry including manufacturing, general engineering, commercial inspection, etc.
The PTG-3525 comes complete with 2pc external probes. 1pc Ferrous and 1pc Non-Ferrous probe, 2 substrate samples(steel, aluminum), 4 calibrated thickness specimens, carry case, batteries and operation manual.
Active Questions & AnswersAsk a Question
There are no current Discussions
Need Equipment Support?
Documents & Manuals
There are no Documents or Manuals available.
Features
There are no Features available.
General Specifications
| Weight | 5 lbs |
Additional Specifications
Measuring range:
0-1000 u m max. or 0-40 mils
Resolution:
0.1 u m / 0.01mils(0-99u m) or 1u m (over 100u m)
Guaranteed tolerance:
After one-point calibration: +/- 1-3%n or 2u m (whichever is greater)
Display:
4 digits (digit height = 10mm/0.4”)
Min. measuring area:
0.2” x 0.2” (5mm x 5mm)
Min. radius of curvature:
Convex: 0.12” (3mm)
Concave:
1.2” (30mm)
Min. substrate thickness:
Ferrous: 20 mils (0.5um)
Non-ferrous:
2 mils (50u m)
Calibration:
Zero Calibration; Foil calibration
Max. Surface temperature of test object:
302 degrees F (contact time max is 2 seconds)
Power source:
4 AA batteries
Dimensions:
161 x 69 x 32mm