Phase II - Surface Roughness Tester

Manufactured by  Phase II
Follow this Equipment

The PHASE II SRG-2000 surface roughness tester is a pocket-sized economically priced instrument for measuring surface roughness texture

The PHASE II SRG-2000 surface roughness tester is a pocket-sized economically priced instrument for measuring surface roughness texture conforming to traceable standards. It can be used on the shop floor in any position, horizontal, vertical or anywhere in between. The large LCD display shows either surface roughness parameter Ra, Rz, Rms(Rq) and Rt at the touch of a button, combined with the selected cutoff length. External calibration of the surface roughness values is possible by means of a special CAL button, which makes adjustment of this instrument very easy. A beep signal informs the user about each individual measurement status when ready. 
 
The easy to use SRG-2000 surface roughness tester operates on various surfaces, not only flat but also outer cylinder, outer cone, grooves, and recesses greater than 80x 30mm. 
 
The areas of application are wide spread. It is suitable for inspection departments, quality control, on the shop floor during machining, during assembly in the field. 
 
The SRG-2000 determines surface roughness parameters Ra,Rz, Rms(Rq) and Rt within a wide measuring range. The piezo-electric pick-up stylus with diamond tip assures a very reliable measurement within tolerances that conform to ASME B46.1. Surface Roughness parameter Ra is computed to conform to ISO and Rz is computed to conform to DIN. 
 
The PHASE II SRG-2000 surface roughness tester comes complete with a compact durable carrying case, roughness standard, charger and instruction manual.
Active Questions & AnswersAsk a Question

Hardness Testers Service ProvidersView All (2)

Request Support
Documents & Manuals

There are no Documents or Manuals available.

Features

There are no Features available.

General Specifications
Depth 26 mm
Height125 mm
Width 73 mm
Weight200 g
Additional Specifications

Surface Roughness parameter: 
Ra (ISO), Rz (DIN), Rms(Rq), Rt 
 
Measuring range: 
Ra: 0.05-10.0µm / Rz: 0.1-50mm 
Rq: 0.05 ~ 10.0µm / Rt: 0.1 ~ 50µm 
 
Resolution: 
0.01µm (1.6minch) 
 
Cut-off lengths: 
0.0009in., 0.03in., 0.09in 
 
Filter RC analogue 
 
Tracing length: 
0.23in (6mm) 
 
Tracing speed: 
0.04in/second (1.0mm/second) 
 
Accuracy: 
+/- 12% of actual Value 
 
Pick-up stylus: 
Piezo-electric 
 
Tracer tip: 
Diamond, radius 5µm 
 
Operating temperature: 
32-104 degrees F (0-40 degrees C) 
 
Power: 
3.6v / 2xNiMh batteries 
 
Charger: 
9V DC 
 
Contact force on probe: 
<1.8ozf (<50gf) 
 
Static measuring force of sensor stylus: 
<0.06ozf (<1.6gf)

Videos
  • Surface Roughness Tester-Phase II SRG-2000 Surface Roughness Tester

Looking for New or Used Equipment?

Shop on LabX

Shop on Labx.com