1. Home
    2.  / 
  2. Basic Laboratory
    3.  / 
  3. Cleanroom Equipment
    4.  / 
  4. Workstations
    5.  / 
  5. AirClean® Systems - PowderSafe Type C Enclosure

AirClean® Systems - PowderSafe Type C Enclosure

Manufactured by  AirClean® Systems
Follow this Equipment

A universal enclosure built with the application and operator in mind

AirClean Systems Type C PowderSafe™ balance enclosure incorporates the user-friendly features and chemical fume containment capabilities of the ductless fume hood with airflow dynamics and HEPASafe™ features of the PowderSafe Type B. Thermally fused polypropylene makes the PowderSafe Type C enclosure perfect for powder or solvent weighing, manipulation and enclosing weighing equipment. Fitted with the AirSafe™ automatic safety controller, the Type C PowderSafe has an even laminar flow airstream for accurate weighing. 
 
The entire rear wall of the enclosure is a filtration zone; a clean sweep of all particulate and gases is achieved. This design feature makes the Type C PowderSafe ideal when weighing the lightest powders or the heaviest solvents. 
 
AirClean Systems HEPASafe filter change-out technology, incorporated into each PowderSafe Type C Powder Enclosure, allows the operator to safely and effectively change both the pre-filter and primary HEPA filter. Standard on each Type C enclosure is the AirSafe Automatic Safety Controller. The face velocity on the PowderSafe Type C Enclosures, as preset by the operator, is constantly monitored and maintained by the AirSafe™ Automatic Safety Controller. AirSafe™ monitors the condition of both HEPA filters and provides audible and visible alarms when filter change out is necessary.
Active Questions & AnswersAsk a Question

There are no current Discussions

Need Equipment Support?

Request Support
Documents & Manuals

There are no Documents or Manuals available.

Features of PowderSafe Type C Enclosure

Standard Features 

  • Horizontal laminar airflow pattern * AirSafe™ automatic safety controller * Permanent backup HEPA filter * Effectively weigh to 7 decimal places * Integral vapor-proof fluorescent lighting * No ductwork required * No installation required - plugs directly into a standard 110V or 220V electrical outlet * Polypropylene construction for chemical resistance. The result: NO RUST * Constant monitoring of fume hood face velocity with variable airflow control to user preset value * Gas phase bonded carbon filtration * Lab event timer 

    Safety Features * HEPASafe™ technology allows safe HEPA filter change while enclosure is operational * ASHRAE 110 tested * Brushless, sparkless blower is post-filter * Deep base effectively contains accidental spills * Electronic gas detection for real-time gas phase filter monitoring * Exhaust air is HEPA filtered, keeping any potential particulate from returning to the room * Filter and electronics are located above the workspace, eliminating the chance of a chemical spill entering these sensitive areas * Filter safety lockout to ensure correct filter replacement * Low airflow alarm warns the user both visually and audibly * Real time monitoring of installed filtration bed * Shipped fully assembled * Tested to UL 61010-1 and CSA C22.2 No. 61010-1

General Specifications

There are no General Specifications available.

Looking for New or Used Equipment?

Shop on LabX

Shop on Labx.com