Eksigent - ExpressHT™

Manufactured by  Eksigent
Follow this Equipment

Designed for high throughput bioanalysis with excellent reproducibility, while saving up to 95&#037 of the solvent.

The predominant analytical approach for quantitative pharmacokinetic and drug metabolism studies is to utilize HPLC in combination with mass spectrometry. However, the growing number of samples that are being analyzed in today's drug discovery and development labs are pushing the limits of current LC/MS system performance and throughput.

In response to these increasing demands, MS vendors continue to refine their systems for faster and more sensitive detection and quantitation. In contrast, a general-purpose HPLC system with inadequate flow control and response time for such fast separations is used for many LC/MS/MS bioanalyses. As a result, only a fraction of the potential analytical throughput is being realized.

With the release of the new ExpressHT-Ultra, Eksigent meets this challenge by delivering a short-cycle time, high-throughput HPLC system specifically designed to maximize the performance of today's mass spectrometer.

The ExpressHT-Ultra's maximum pressure of 10,000 psi enables the use of small particle size stationary phases that deliver narrow peaks to mass spectrometers. Plus, the ExpressHT-Ultra incorporates Eksigent's proprietary Microfluidic Flow Control to ensure excellent flow rate precision for small molecule analyses. The use of small internal diameter columns, combined with low flow rates and fast cycle times, results in up to 95% solvent savings.
Active Questions & AnswersAsk a Question

There are no current Discussions

HPLC Systems Service ProvidersView All (54)

Request Support
Features

There are no Features available.

General Specifications
Depth 20 in
Height28 in
Maximum Pressure10000 psi
Width 25 in
Power Requirements 100 - 240 V
Standard Flow Rate 50 to 200 µL/min
Weight55 lbs
Additional Specifications

Flow rate accuracy: < ± 1%
Flow rate precision (RSD): < 0.5% @ 150µL/min
Sample capacity:


  1. 6 tray positions
  2. 54 - 2mL vials
  3. Standard or deep 96-well microplates
  4. 384-well microplates

Injection valve:

  1. 1/32" connection Port-to-port volume < 60nL
  2. Maximum pressure 10,000psi
  3. 316 Stainless steel; proprietary coating

Injection volume range: Programmable from 0.5 - 10µL
Injection reproducibility:

  1. Full loop: < 1% RSD
  2. Partial loop: < 2% RSD

Sample cooling: 4°C to 40°C
Gradient delay: Less than 10 µL
Column oven: Ambient +5°C to 80°C
Column length: 3 - 10cm
Wetted parts: 316 Stainless steel, PEEK, PEEKSil, fused silica and FEP
Instrument control: Eksigent software with plug-ins for ThermoFisher Xcalibur, Bruker Daltonics HyStar and ABI/MDS Sciex Analyst software

Looking for New or Used Equipment?

Shop on LabX

Shop on Labx.com