Shimadzu - SIL-HTa/SIL-HTc
SIL-HTa/SIL-HTc
Active Questions & AnswersAsk a Question
Recent Questions & Answers
Asked byDennis Yasuda
Autosamplers Service ProvidersView All (1)
Documents & ManualsView All Documents
Features of SIL-HTa/SIL-HTc
High throughput The SIL-HT maximizes analysis throughput with fast sample injection and high sample capacity. Injection speed is 15 seconds for injecting samples of 10uL .
Near-zero sample carryover Recently, an increasing number of extremely basic and hydrophobic components are being used in new drug formulations. Since these chemical compounds strongly adsorb to the sampling needles or rotor seals (mainly Vespel) of autosamplers, cross contamination may not be reduced by simple rinsing. To minimize adsorption of such compounds, the outer surface of the sampling needle of the SIL-HT's autosampler is coated using a special, innovative surface processing technology (patent pending). Furthermore, by employing newly developed rotor seals and needle seals made of PEEK, the SIL-HT dramatically reduces contamination, even with the most highly adsorbent sample compounds. As a result, the SIL-HT demonstrates nearly zero sample carryover. Excellent repeatability The SIL-HT uses a needle-in-the-flow-path injection design (also called direct injection method or total volume injection method) and a high-performance measuring pump (6nL step resolution) for enhanced accuracy. This results in superior repeatability over conventional autosamplers. In addition, precious samples are not wasted since the total volume aspirated is injected.
General Specifications
Cross Contamination | 0.01 % (for analysis of naphthalene) |
Depth | 500 mm |
Height | 415 mm |
Maximum Pressure | 20 MPa |
Width | 540 mm |
Power Requirements | AC100V, 150VA (SIL-HTa), 300VA (SIL-HTc), 50/60Hz |
Optional Injection Range | 1 to 2000 μL |
Standard Injection Range | 0.1 to 100 μL |
Weight | 40 kg (SIL-HTa), 45kg (SIL-HTc) |
Additional Specifications
Sample Injection Unit
Sample Injection System: Total sample injection, variable sample injection system (zero sample loss during injection)
Sample Processing Capability:
With 1-mL vials: 350
With 1.50mL vials: 210(SIL-HTa), 140(SIL-HTc)
With 4-mL vials:100
With micro plates:4 (96 wells: 384, 384 wells: 1536)
With deep-well plates: 4 (96 wells: 384, 384 wells: 1536)
Injection Volume Repeatability: RSD: 0.3% max. (at 10µL injection)
Injection Volume Accuracy:
Less than +/-1% (50µL)
Injection Volume Accuracy Correction:
Possible
Number Of Injections:
1-99 times per sample
Settting Of Analysis time:
0.01-9999.9
(0.01 minute increments to 999.099min.,0.1 minute increments over 1000min.)
Number Of Steps For Injection Conditions:
Max 102 steps
Sample Suction Speed:
0.1 - 15µL/sec (0.1µL/s step for 0.1-0.9µL/sec., 1µL/s step for over 1µL/sec.)
Rinsing Liquid Suction Speed:
1 - 35µL/sec (1µL/s step)
Operating pH Range:
pH: 1 to 14 standard
Wetted Surface Material:
SUS316, PEEK, Ceramics
Operating Temperature Range:
4 to 35°C
Operating Humidity Range:
up to 70%