Discussion Category:  Centrifuge

Beckman Avanti J-HC Centrifuge - R1 Rotor not Identified Check rotor.

We have J-HC centrifuge that was working fine until the JS 5.0 rotor was added to it that was slightly imbalanced and appears that it got centrifuge out of calibration.

We had JS 5.0 rotor balanced, but now we are still getting "R1 Rotor not Identified Check rotor." We also tried placing original JA-10 rotor back that we previously used but the error persists anyway.

Please advise on the reset/calibration procedure of this centrifuge. Answers that are listed on this board for avanti centrifuges only mention the models with knobs.

Not sure if anyone might have a service manual for it. Any advice greatly appreciated.

avatar placemark

Asked by

LabTechs
Report this Post

Page 1 of 1