Discussion Category:  Segmented Flow AnalyzersFlow Injection Analyzers

the fs 3100 dont show the concentration of the exdamples

we work with fs 3100 cyanide analyzer, it start to run normal, but we do sincronization  and it dont show the concentration but it show the picos.

avatar placemark

Asked by

oxidos
Report this Post

1 Reply

EZkemReply by
EZkem

Hello

There are probably a few reasons for this. The first thing I wonder is if the calibration is set to weighted linear which requires three standards but you are only injecting single standards?

If you send me the .rst file I will send it back to you fixed and give you screen shots of what the problem is.

Ken@ezkem.com

if the peaks show then it can be fixed no problem just send me the result file.

Ken Earle

EZkem

www.ezkem.com

ken@EZkem.com

Ken Earle,
EZkem
541-387-0343
www.EZkem.com
Report this Post

Page 1 of 1