Discussion Category:  Balances

Adam AQT200

I removed my Adam balance from the storage cabinet and started it up.  It cycled up to 999999 on the out put screen and stopped.  

It will not reset, change units, or in any other way work.


Any suggestions?

avatar placemark

Asked by

Report this Post
avatar placemarkReply by

I had an ADAM QT-200 that did exactly this. it came to the workshop with a 12VDC NOT the required 12VAC power supply. Therefore the voltage received by its electronics is to low (12VAC will convert to just under 17VDC inside the balance). Fitting the correct power supply fixed the problem.



Report this Post

Page 1 of 1