Discussion Category: Titrators
Connecting RS-P26 printer
We have the RS-P26 printer and are trying to get it to comunicate with the T70 titrator. I have configureded all settings to match printer with titrator. Keep getting no connection message on printer. What should I try?
Reply byWhat is the firmware of the T70? Is the T70 set for printer RS-232 Compact printer? Which COM port is the printer connected to?
Jennifer Burkman
METTLER TOLEDO
www.mt.com
Reply byFirmware version is 3.1.2. Only choice for compact printer is USB. Have tried RS-232 and RS-232 Data Export. Have tried both COM 1 & 2. Have tried different BAUD rates, parity bits, and handshake. To no avail.
Reply bySelect under Setup>Hardware>Peripherals>Printer type, set to RS-232. The parameters cannot be changed and the printer must be changed to match. The Balance feature needs to be Disabled.
Jennifer Burkman
METTLER TOLEDO
www.mt.com
Reply byThat seemed to work. Not getting Not Connected error any longer. Green power light now on steady. Thanks.
Reply byWhen trying to print after a test has been done receiving message that "Function Disabled". Unable to solve this issue.
Reply byWhat parameters in the Record function are you wanting to print? Any titration curves? Can you print the method?
Jennifer Burkman
METTLER TOLEDO
www.mt.com
Reply byHave not been able to print anything. Printer just gives the message "Function Disabled". Can't seem to figure out how to enable.