Discussion Category: Centrifuge
Epopendorf 5415R won't turn on
I have looked at the various answers over the issue of the centrifuge not turning on after it has been turned off. The 5415R control board is different than the 5415D. I have tried to replace the the 2.2uf capacitor to a 10uf capacitor as explained without any success. Also the four 68K resistors are replaced with 8 ohms and add up to 32 ohms. The same situation happens when the ribbon cable is disconnected while the power is on, it will reset. Does anyone have any ideas!
Thanks for your help
Guri