Discussion Category: Checkweighers
Hi-Speed RX2
all 3 conveyor motors will not run. They seem to engage but no movement, and then I get the following fault. "motor protection: motor stop (0) 2001". Any help or expertise would be appreciated. Already swapped out the SXP module and tried a known good motor swap on all 3 conveyors.
Reply byHiSpeed RS2 is not supported at this forum or address.
Please call 800-836-0836
Jennifer Burkman
METTLER TOLEDO
www.mt.com
Reply byID tag on the equipment shows RX2. Was hoping for some technical help since M.T. is not supporting our older checkweighers anymore. Very hard to find any forums at all that discuss the older in lines. If I were in charge of Purchasing we would get them all replaced, but unfortunately I am just the guy that has to try and keep them running.
Reply byThis forum is for products used in the Laboratory only. Hi-Speed is a different division, at a different location and is a sister Mettler Toledo company
Jennifer Burkman
METTLER TOLEDO
www.mt.com