Discussion Category:  Centrifuge

diag. S2

Can anyone tell me how to erase this S2 diagnostic from a J-26XPI.

avatar placemark

Asked by

Guri
Report this Post
avatar placemarkReply by
dpkleessr

According to my service manual information, an S2 diagnostic is indicative of a bad EPROM #2 on the CPU board. As such, there is no reset code for that kind of error that I am aware of. On the off chance that it is some kind of intermittent issue, try using the procedure for clearing an S7 diagnostic but I will be surprised if that works.

Don

Report this Post
avatar placemarkReply by
dpkleessr

According to my service manual information, an S2 diagnostic is indicative of a bad EPROM #2 on the CPU board. As such, there is no reset code for that kind of error that I am aware of. On the off chance that it is some kind of intermittent issue, try using the procedure for clearing an S7 diagnostic but I will be surprised if that works.

Don

Report this Post

Page 1 of 1