Discussion Category: Bulk Density Tester
Density Drift
Within two weeks of installing this new DMA 5000M I experienced rapid drift in my water density check. I have seen densities as high as 0.998238 using the same water in the same conditions. Note I have an older DMA 5000 which uses the same water was well and water checks comes out fine. What could be contributing to this rapid drift?
Reply byAPUSAM
This is Jeff L. at Anton Paar - thank you for your post, and for choosing Anton Paar!
If possible, please call us at 804.550.1051, and our service department can help. There are a wide variety of potential causes here, and we will be happy to help diagnose the correct one.
Thank you!
Jeff L.
Anton Paar USA