Discussion Category: Centrifuge
J-25 Rotor Calibration
Hello, in my job we have a Beckman Coulter J-25 centrifuge that indicated the error "S7".
This was already solved by doing the general reset, following the steps we find in this forum.
Now we need the rotor calibration procedure. Would someone be so kind as to facilitate it?
I leave the data of the equipement:
AVANTI CENTRIFUGE
MODEL J-25
CAT NO 363104
SER JHY05E05
Thank very much in advanced.
Best regards!
Sorry for the bad english
Reply bydpkleessr
Your English is fine. If you follow the instructions for reinitializing the centrifuge then that is all that you need to do. There is nothing special that you need to do for the the rotor itself. Just make sure that you follow ALL of the steps that I previously posted.
Don