Discussion Category:  Centrifuge

Imbalance error after Board replacement

Does anyone have the calibration procedure to use following the board replacement

avatar placemark

Asked by

JStone1963
Report this Post

2 Replies

avatar placemarkReply by
WarwickJon

Hi, 

Have you tried contacting Eppendorf direct?  I've done the procedure on the 5810's but dont know if its the same for the 5804.

Cheers, Jon

Report this Post
avatar placemarkReply by
JStone1963

we were able to contact them and worked through the issue. Thanks for the reply.

Report this Post

Page 1 of 1