Discussion Category:  Coagulation Analyzers

Serial Port Data Connection Issue

Hello All,

New to the forums...

We are a small hospital lab and trying to setup the interface with a CA660 and Mcesson's SD2 autoverification Software. I use a DB9 serial Adapter to convert to a RJ45 data cable to a Digiport Term Server then to the SD2 software.

My problem is I do not know how to test to see if data is coming off the analyzer. Is there a test I can hook up to my laptop to confirm the Pinouts on the DB9 connector are correct?

Ultimate goal is to see the CA 660 data in the SD2 tracer software but we are not there by a long shot. Help!

Mark

avatar placemark

Asked by

Mark4545
Report this Post

0 Replies

Page 1 of 1