Discussion Category:  Centrifuge

Error 6 00 00

Here is my problem. I replaced the main board after a wire shorted on the fan. It ran great for three days and then threw an error code 6 00 00. I checked the fan and it is ok, Checked the brake resistor which was in spec. Power to board 120, Ref. fan motor seems ok. Motor spins freely and i get a reading of 5.3 ohms between any of the three wires. Lid motor works fine. I tried disconnecting the main power draw wires. The fan power, the ref. fan power, resistor wires, lid power motor wires Still same error code. Eppendorf is sending me another board but want advise before i put it in. Thanks
avatar placemark

Asked by

cmuse15787
Report this Post

Page 1 of 1