Discussion Category:  FT-IR Spectrophotometers

setting the value of the laser signal

We have a Cary 630 type FTIR spectrometer and we encountered a problem with setting the value of the laser signal which is lower than the standard and the device no longer takes measurements, we are not given a hand to set the value and by adjusting the energy gain within the accepted standards (29000-21000) the value of the laser signal always remains below 2000. Here is the corresponding screenshot attached
avatar placemark

Asked by

cheraitiaabdellah8750
Report this Post
avatar placemarkReply by
gemalem1431
Hello Dears, I am facing the same problem at many customer sites. Is there anybody who can provide support?
Report this Post

Page 1 of 1