Discussion Category:  Dynamic Mechanical Analysis

Q800 doesn't power up

The DMA Q800 was powered off for a brief period. Tried turning it on again, the instrument doesn't turn on. Checked the fuses, they are fine. Any advice on this. Thank you.
avatar placemark

Asked by

pkeesara366427
Report this Post

2 Replies

avatar placemarkReply by
LabWrench2844668

Hello,

Be sure the electrical soket you are plugging into has power. If that is fine, turn on unit, there is a cooling fan on the back of the unit, is the fan on ?

Reach out to me and I will send you pictures and what to look for on the power unit. brivas@rtimnsturments.com

 

Thanks

Report this Post
avatar placemarkReply by
LabWrench2844668

Correction to email brivas@rtinstruments.com

Report this Post

Page 1 of 1