1. Home
    2.  / 
  2. Forums
    3.  / 
  3. Basic Laboratory
    4.  / 
  4. Incubators
    5.  / 
  5. CO2 Incubator
    6.  / 
  6. Thermo Forma 3110 Water Jacketed CO2 Incubator
    7.  / 
  7. Condensation Issues

Discussion Category:  CO2 Incubator

Condensation Issues

So I have a incubator with condensation on the inner glass door. Got the fan working again changed the wires to the door heater check to make sure that was working and replaced the gasket since there was a gap. And now there's still a gap. It's in both corners opposite the hinges I can slide a card between the door and the gasket. How do I readjust the door or how tightly it closes?

Equipment: Thermo Forma - 3110 Water Jacketed CO2 Incubator

avatar placemark

Asked by

Vertver
Report this Post
avatar placemarkReply by
KieraCharlton
Hi, If your incubator door is not closing tightly, it could be due to several factors, including misalignment of the door, improper installation of the gasket, or warping of the door or frame. You can adjust the door latch: If the latch is not holding the door tightly closed, adjust the latch mechanism using a Phillips head screwdriver. Loosen the screws holding the latch mechanism in place, adjust it to the correct position, and then tighten the screws again.
Report this Post
You must be Signed in to Reply

Page 1 of 1