Discussion Category:  Microwave Digesters

Error 001-023

The reactor send this message and stop the experiment: Heating rate was insufficient. Error 001-023. Someone has fixed the problem? Any idea what is going on with the MW? I just read that the MW could start if the P/T sensor is off, it is safe to do this? Thanks, Jose
avatar placemark

Asked by

olivaresjlo2154
Report this Post
avatar placemarkReply by
Rene

Hi,

the message is an indication that the target tempreature could not be reached within the time specified in the method.

This can have different reasons, from low absorbing reagents, too fast heating ramps, up to an technical fault of the instrument.

Do you have any run-data to share? You may send the data to support-asc[at]anton-paar-com

(
or you can contact us / our local subsidiary by using the online contact form:
https://www.anton-paar.com/us-en/contact/?typereq=1
)

Best regards,

René

Report this Post

Page 1 of 1