Discussion Category:  PCR / Thermal Cyclers

Error code 1006

While running a program, it will get only a few minutes into it, then flash this error. I haven't been able the find any information on this error code. Any help would be greatly appreciated.
avatar placemark

Asked by

Report this Post
avatar placemarkReply by
If you have lid pre heat on and the lid is getting up to temperature fine, then when the block starts heating you get this then there could be an issue with the block, likely one of the sensors.

Zak Purtell
Workshop/Field Engineer

Labcare Service Ltd
1A Chapel Hill
Braintree, Essex
Tel: 01376 332909
Service, calibration, repair and sales of laboratory equipment.
Report this Post

Page 1 of 1