Discussion Category: PCR / Thermal Cyclers
Error code 1006
While running a program, it will get only a few minutes into it, then flash this error. I haven't been able the find any information on this error code. Any help would be greatly appreciated.
Reply byZakLabcare
If you have lid pre heat on and the lid is getting up to temperature fine, then when the block starts heating you get this then there could be an issue with the block, likely one of the sensors.
Zak Purtell
Senior Engineer
Labcare Service Ltd
www.labcareservice.co.uk
Tel: 01376 332909
Service, calibration, repair and sales of laboratory equipment.