Discussion Category: PCR / Thermal Cyclers
Many error message: block; lid; CPU; Control panel
Hi all,
Does anybody have problems same to mine?
- Turn on PCR
- error code displayed:
+ 0x010A: ablaufproxy cycle 1
+ 0x0D05: Lid type invalid
+ No Cycler available
+ 0x0D01: TmodProxy CPU_GetSerNr
+ 0x0D04: BLK_Get Block type()
PCR model: 6325
control panel model: 6320
Thanks
Equipment: EPPENDORF - Mastercycler pro S
Reply byDaytonSporer
I also encountered the same situation.
Reply byOldNavy
The computer board has failed. MedRun, a laboratory equipment service provider may be able to repair the board/unit.
Reply bydsetty
Dang. We just received a pile of 8 of these (some Pro 6321 and some Pro S 6325) and 5 have this issue, while only 3 fully function.
Device: 3 ControlPanel
ErrorCode: 0x010A
Cycler No:1
Error reading version of power supply unit.
Please check the cycler software version and cycler number.
I've the same error above on with this at the bottom:
ablaufproxy Cycler 1 GetStatus()
And another:
Thermomodule: GetVerionProxy()
I've seen the 0x0D05 error as well. LidType Invalid:0
I'll poke around, but 5 bad units with the same error. Maybe a power issue. Weird.
+ 0x0D05: Lid type invalid + No Cycler available + 0x0D01: TmodProxy CPU_GetSerNr + 0x0D04: BLK_Get Block type() PCR model: 6325 control pa
Reply bydsetty
So much for my pretty formatting. It was extremely readable before I hit submit.