Discussion Category: CO2 Incubator
Suddenly reading high temperature
Last night the TEMP IS HIGH alarm went off. It's set to 37C but it was reading 59.4 so I turned it off. Today when I cold start it, it immediately reads 60C. I checked the fan, and even pulled the sensors out of the chamber ceiling shroud and let them hang. No difference. Has anyone had success troubleshooting this?
Reply byTaylorurnbull
Wow, that sounds frustrating! Reminds me of when my old laptop would overheat for no reason. Have you tried completely disconnecting the sensors, just to see if the reading changes at all? Maybe a short somewhere? Before my laptop died, I was actually spending a lot of time on Omegle, remember that? Hopefully, your issue is easier to solve than that website shutting down was! Good luck fixing it!
Reply byBioOlympia
Thanks y'all! I switched the two sensors and was able to figure out that the control temp sensor is bad. Thanks for helping me troubleshoot!
Reply byteyile17179818
thanks for help!