Discussion Category:  CO2 Incubator

Napco - CO2 6500

Hello, I am reaching out regarding a Napco CO2 6500 incubator that is displaying an H20 error and is not operating properly. We have already filled the water jacket to the recommended level (approximately 4–5 cm below the fill port, as indicated in the manual). However, the H20 error remains, and the incubator does not appear to be functioning correctly. Although the unit powers on, the temperature is not increasing and the incubator is not heating. We would appreciate any guidance on troubleshooting this issue or recommendations for additional steps we should take to clear the error and restore normal operation. Thank you for your assistance.

Asked by

20066804

avatar placemark

Asked by

20066804
Report this Post

Page 1 of 1