The following steps should help:
-
Turn off power
-
Disconnect from main power source
-
Disconnect blue & brown wire inside electrical cabinet for work light (make note of which wire went were)
-
Feed wire through electrical cabinet
-
Feed wire through back of saw
-
Feed wire through back of hood
-
Disconnect light from saw hood
-
Remove old work light
-
Feed new work light wire through hood
-
Feed wire through back of saw (leave some slack in wire for hood to open and close)
-
Feed wire back into electrical cabinet
-
Install new work light in saw hood
-
Reconnect wire inside of the electrical cabinet
-
Hook saw up to main power
-
Turn on instrument
If you have additional questions, please contact LECO Service at 269-982-5497 or info@leco.com