Gage Tech.

The following steps should help:

• Turn off power
• Disconnect from main power source
• Disconnect blue & brown wire inside electrical cabinet for work light (make note of which wire went were)
• Feed wire through electrical cabinet
• Feed wire through back of saw
• Feed wire through back of hood
• Disconnect light from saw hood
• Remove old work light
• Feed new work light wire through hood
• Feed wire through back of saw (leave some slack in wire for hood to open and close)
• Feed wire back into electrical cabinet
• Install new work light in saw hood
• Reconnect wire inside of the electrical cabinet
• Hook saw up to main power
• Turn on instrument

If you have additional questions, please contact LECO Service at 269-982-5497 or info@leco.com