Discussion Category:  Differential Scanning CalorimetryCalorimeters

calibration

How to input heat capacity calibration constant manually to the equipment software after doing sapphire calibration?

 

avatar placemark

Asked by

Haryo
Report this Post

3 Replies

avatar placemarkReply by
LabWrench2844668

Hello,

 

Contact us RT Instruments Inc. 530-666-6700

www.rtinstruments.com

We can assist you with any needs and consumables you have for your TA Instruments Q2000.

 

 

Report this Post
LabWrenchEditorReply by
LabWrenchEditor

Hi Tito,

Although it is your choice to go offline with your discussion, we are sure that other LabWrench users would appreciate if you kept your discussion within the thread. This will help to keep a permanent record of the issue that members are facing and how it was solved to help others in the community that may be facing a similar challenge. 

We appreciate your participation.

Best regards,
The LabWrench Team


Kylie Sauve
LabWrench Site Manager
kylies@labwrench.com


Stay Connected with LabWrench:
Follow us on Twitter
Like us on Facebook
Join the Lab Equipment Solutions Group on LinkedIn
Report this Post
avatar placemarkReply by
LabWrench2844668

Hello,

 

Sometimes direct contact with the end user will be faster than going back and forth on the forums. For heat capacity, it is crucial that you have a known excellent working balance. The heat capacity is directly affected by the weight. If it is out of specs, you will have to go through the Wizard and perform full calibration. If you need assistance with it, please call me. I will walk you through procedure.

 

Tito 530-666-6700

Report this Post

Page 1 of 1